2006 dodge ram 2500 5.9l cummins evo all wire diagram. I have lights on box but will not start.

Question

I have the t harness with the chrt5, I went thru the flash link but do not have an option for diesel or delay start or fuel pump prime

Answer 1

Click on the gear icon in the top right corner and select "go to pro mode".  You will be able to enable the diesel delay manually. Option D1.3.

 

For the install, you need to follow connection F in the guide and not connection C.

https://cdn02.fortin.ca/download/28831/evo-all_evochrt5_p20160902-2.pdf

 

 

 

Comments

i have entered pro mode but it is not letting me change any of the diesel setting, i have installed firmware 74.22 but i cant select and change delay startup or runtime

---

Turn off settings protection. It will then give you access to change the options.

 

Provide the 12 digit service number of the evo-all if that's not the problem.

---

I've tried resetting it and refreshing unit and set all parameters, nothing is working and I have spliced every wire in connection f. My SN is 001A07 116483

---

How many times does the red led flash when it fails to remote start?

---

It stays on threw the start up cycle, then comes on again for the second start attempt, I think at the end it flashes 3 times is what I want to say

---

Are you using t-taps on the connections at the ignition switch? or any type of plastic connector.

---

They are the plastic alligator style slide 2 wire in then clamp it. Do I need to cut and solder the wires then heat shrink for better connection

---

look up military splice, or poke and twist.

---

Thank you very much I guess when I alligator clipped them they were not a good enough connection, i cut and soldered and heat shrunk the ignition wires and the yellow ignition wire and now it works perfectly