2009 hyundai elantra manual transmission no clutch wire diagram

Question

Can someone pls help me find a wirinf diagram for 2009 hyundai elantra GL manual transmission. I can only find the automatic transmission wiring diagram. Any help will be appreciated. Thanks in advance

 

 

Answer 1

follow the automatic guide but you will need to wire the clutch.

 

Clutch is (+) trigger at clutch switch. Wire can be Red or Grey per information on wirecolor.com

Comments

it's a white 2 pin plug at clutch pedal! pin #1 ( Gray ) shows  12 volt when ing and clutch is depressed! So just use the Starter wire from your remote start and wire it to the Gray wire on 2 pin clutch plug! :)  That SHOULD SOLVE YOUR ISSUE! Cheers (Mad Man Audio)

---

Thanks for the reply. So since it is a (+) trigger, can i just use the same Starter(yellow) wire from the 6pin main harness of the evo one? Or do i have to use the white(-) trigger wire from the 20pin harness and a relay to make it a positve trigger? Thanks again

---

I will quote Mad Man.

 

So just use the Starter wire from your remote start and wire it to the Gray wire on 2 pin clutch plug! :)  That SHOULD SOLVE YOUR ISSUE! Cheers (Mad Man Audio)

---

Thanks for reply. So basically connect the yellow starter wire from the evo one 6pin main harness to both the gray wire from the clutch trigger and the starter wire from the steering column? Thank you so much guys.

---

don't need to connect it to the +Start wire at the ignition switch, only to the clutch. You wouldnt want to that anyway without properly isolating both circuits.

---

That is good to know. I wouldve connected both if i didnt ask. Sorry for all the questions.  Thanks for the information guys.