Questions & Answers

can not get module to program in car

0 votes
I have a 2012 Fusion. Installing EVO-FORT1. So far I have connected the T-harness and the can Hi and Low. The module will not program to the car. I am using guide # 32171. I have not connected any other wires.I.E parking light or drivers door pin. The schematic shows 3 other wires(yellow ign,Lt blue/black andLt blue) going to the T-harness from the 20 pin connector but does not elaborate on how they should be connected. Where did I go wrong?
posté Dec 28, 2017 dans la catégorie Ford par Randall Bissi (160 points)

1 Réponse

0 votes
The module will not program if yellow, light blue and light blue/black are not connected....

Those connections must be made between the module's 20 pin connector and the tharness. They are not connected to the vehicle.
répondu Dec 29, 2017 par Mathieu Bertrand Collin (62,040 points)
Connected 3 wires from t-harness to 20 pin connector. used 2 key proceedure module light show it is programed but car will not start with either remote. could not get d-criptor to work with 1 key. I have flash link. All "a's" are on "c and d1" on and "d"1.6 on.saved settings but when I hit flash, nothing happens.
Helps when you have all 4 door closed. now the car starts anruns for 1 minute then shuts off. Module flashes 3 times. I have run time set to 15 minutes.
...