unable to program EVO-ALL for 2015 CR-V(Push-to-Start)

Question

Hello there,

I have an EVO-ALL with firmware to date Ver.73.14.  I am trying to program the unit for 2015 CR-V (Push-to-Start) from the Programming Procedure instructions/GUIDE#23341/REV.:20141112.  I was able to follow up to step 4 (page 3/5)  then I stucked at step 5 because the "RED and BLUE LED still flash 2x/sec"...even I tried to "Push the Start botton 2x on the vehicle..." and many times later...still failed?

I did not see the "YELLOW LED" flashing on? or BLUE LED blinking? or any alternation between of the "YELLOW and RED LED" on?

Can you please tell me what did I miss here?

Thank you very much,

Nhut

 

 

Answer 1

If the red and blue keeps flashing, the yellow wire on your EVOALL is not connected to ignition. Veriify this connection.

Comments

Hi Mathieu,

I will check the yellow/ignition wire's continuity again this coming weekend.  I will let you know.

Thank you very much for the info.