Questions & Answers

bypass wont program 2010 ford escape with 2 keys

0 votes
using evo-all fully updared and flashed with thar 4-1 t harnes . there was no obd wireing so i found a harness and spliced can high and low using.

problem is pressed program button conected power conector, released when red light was lit , stayed lit then conected red 6pin  connector and white 5 pin connector(obd).then proceded to cycle two keys 3 times each and presed program button within 5 seconds but light stays red blinking slowly.

Tried this 5 times and twice with out conecting white obd connector but still wont program
posté Nov 14, 2021 dans la catégorie Ford par brian speers (220 points)

1 Réponse

0 votes
What is the S/N number on the back of the module?

 

Do you have a flash link updater?
répondu Nov 15, 2021 par derek g (339,570 points)
service tag 001A06631806

yes i have the flash link updater and loaded the recomended settings for 2010 escape
Can you please try the dcryptor programming and let me know if it goes through (page 9-10-11): https://fortin.ca/download/95081/evo-all_ig_rts_bi_for-escape-2008-2010_key40bits_a_95081.pdf
when i press the button the red light goes out and back on as soon as i let go and dose nothing when i turn on the ignition.
I would check the yellow ignition wire on the 20 pin connector of the evo all first to ensure it is getting voltage when the key is turned on.
...