Questions & Answers

DO I HAVE TO HOOK UP A CLUTCH WIRE WITH EVO ONE AND THARONE-TOY5 T HARNESS ON A 2016 H KEY TACOMA MANUAL TRANSMISSION?

0 votes
I have a 2016 Tacoma and I'm installing an Evo-One with a THARONE-TOY5 T-harness. I am wondering if I also have to hook a wire to the clutch cancell switch or is that done through the T-Harness?

Thanks
posté Mar 22, 2022 dans la catégorie Toyota par Roger LeBlanc (200 points)

2 Réponses

+2 votes
its positive at Clutch Switch, white 2 pin plug, pin 2.

Use the yellow wire on the harness on the E1 connector on evo one, and connect it to the wire given above, seperate the wire by 1 AMP diode strip facing the car side,

or

use the white wire on the 20 white connector at evo one and flip the voltage from negative to positive using a relay, then connect the positive output of the relay to the yellow positive wire at the switch, use the below youtube for that:

https://www.youtube.com/watch?v=3ESNXVxIf-A&t=173s
répondu Mar 23, 2022 par Haidar Jabbar (22,390 points)
That makes more sense. I searched the Evo website for hours and could not find anything about connecting to the clutch switch so thank you very much.
0 votes
It is not done through the t-harness. You will need to hard wire it.

 

If the clutch circuit is negative you can use the small white wire on the 20 pin connector of the evo.
répondu Mar 22, 2022 par derek g (339,570 points)
According to the Tacoma wiring on this site it looks like it's a positive circuit.
...