Questions & Answers

2016 Ram wont start service #001A06 506999

+1 vote
service #001A06 506999  firmware 74.24  evo all and thar-chr6 with astrostart remote   evo programmed properly  when remote starting  evo red light turns on but doesnt crank or start  ignition not turning on.  evo is not getting ign signal from remote (diode installed as per diagram).   when i supply evo with ign on yellow wire truck starts and runs. yellow wire is also connected to pink/green wire on truck.   is this a diode issue? with diode installed properly the evo wont recieve ign signal from remote.
closed with the note: problem solved
asked Feb 23, 2016 in Ram by Douglas Buhs (310 points)
closed Feb 23, 2016 by derek g

1 Answer

+1 vote
Did you check the wire you connected to in the vehicle too see if it is a ignition wire?
answered Feb 23, 2016 by derek g (339,870 points)
Show 8 previous comments
thar-chr6 t-harness    does rap connection need to be made for stand alone
commented Feb 23, 2016 by Douglas Buhs (310 points)
no not mandatory
commented Feb 23, 2016 by derek g (339,870 points)
in stand alone truck remote starts
commented Feb 23, 2016 by Douglas Buhs (310 points)
ok so know we know its an issue with your remote start!!

are you using data or wire 2 wire?

If using data what protocol is your remote starter/evo-all set too?
commented Feb 23, 2016 by derek g (339,870 points)
i just flashed to 74.19  truck remote starts now with diode installed as per diagram  may have a software isssue with 74.22-.24  Thanks for the help and info
commented Feb 23, 2016 by Douglas Buhs (310 points)

Related questions

...