5 amp ignition fuse blowes every time the car is shut off.

Question

I have installed the EVO-FORT1 in a 2015 Ford Focus. Now after the car is shut off either with the remote or key the 5 amp ignition fuse will blow. I have secured all the unsed wire ends and tied everything up. The only things that needed to be connected was the T- harness and the two datalink wires. Is it possible to have a bad interface module or do I need to wire in a relay to the module?

I dont have the servce number because the module is installed under the dash.

Answer 1

Connect wires E3 and E4. Assuming its an Evo One unit.

Comments

It is an EVO FORT1 and there is no plug going into the E connector location. I believe mine get power and ground from the B connector.

---

Ok looks like you have to do the warning on top of page 4.

---

Thank you, that is what I thought I would need to do. I will cut the red wire (B4) and run a 10 amp powered fuse to it and then cut the black (B3) wire and connect it to ground. Thanks for your help!