Questions & Answers

Why will my doors not unlock with OEM fob after remote started 2015 Toyota Tundra SR5?

0 votes
2015 Toyota Tundra SR5 all conections soldered, all other features seen to work correctly.

factory key fob 3x press to start

When i press unlock during a remote start session ths doors do not unlock, only the pakring lights flash.
posté Jan 7, 2017 dans la catégorie Toyota par Randy Smith2 (160 points)
modifié Jan 7, 2017 par Randy Smith2

1 Réponse

0 votes
Toyota remotes don't work with the vehicle running.
répondu Jan 8, 2017 par Mike Evans (1,960 points)
latest firmware, 79.44 +++

double check/test/redo the door lock data connection

In order not to spam this thread, open up a new question if no resolved
I've tried every firmware I could think of and still no luck. For some reason the key fobs are disabled when the truck is running through the remote start system.

 

2015 Tundra Platinum
this is still happening for me too. 2015 platinum CM. firmware 79.49. also, alarm goes off even with D2 set to ON.
i got my horn to work but could never get the doors to unlock after started remotely.

did you guys ever get a fix?

i fixed my non-functional door locks on my 2017 tundra by removing the oem remote start

SOLVED. so in the end, i did a ton of searching on line and inquiring to Fortin to figure this out. its quite simple. after removing most of the bottom of the dash including the lower steering column, heater controls , glove box, kick panels, radio/nav unit and pass side airbag (did not unplug anything), i located the remote start unit (RES) on the pass side , on the left behind the glove box. unplugged this unit and just followed its (RES) harness. it went to the pass side kick panel where i unplugged it from the bunch of plugs in there. there was a gray plug there that fit into the socket i had pulled the (RES) harness from. i then followed the harness in the opposite direction towards the console. At the heater blower, there is a black box that the (RES) harness is plugged into. unplug that and the other white 3 pin connector.(pink wires). just leave that one hanging there. not required anymore. keep following the (RES) harness up and behind the radio. there is a black socket taped to a harness. it has a plug on the left that is a T from the RES harness. it has a bunch of yellow wires coming from it. unplug that T and join the two black plugs together. now for the steering column. the RES harness is plugged into your ignition (key) plug. the original plug is zip tied to the column. they look identical. just swap them.
there now everything is back to a non-oem remote start truck. you can easily install and program your Fortin evo one and now the door locks will activate with your fob.

...