mycar telematic programming- evo one

Question

hello, i am trying to learn the mycar module to the evo one (2016 subaru impreza firmware 1.24).  the insructions say to hold down the programming button for 5 seconds, but nothing happens when holding it down i tried even longer but got nothing. any ideas?

Answer 1

I have the exactr same issue, same firmware version (1.24), except on 2015 Audi A8. I tried all firmware versions down to 1.20, nothing. Commenting here to give this questioin more attention.

Answer 2

Not sure if this is the correct answer but i got it to work if i turned on the ignition than off and back on again and then continued the programming

Comments

Thank you so much for your post. I have a 2016 Ford F150 push-to-start Lariat. In order to program the linkr-lt2 I had to, with the doors closed, turn the ignition on-off-on and then followed the instructions. The Evo-One would not enter valet mode by just holding the valet button for 5 seconds. My link-lt2 is working great with my Evo-One and THAR-FOR-3 harness.

Answer 3

Also the "program" button is the valet button. The light you will be looking for is where the yellow loop is that you have to cut for auto.

Answer 4

I have a 2016 Ford F150 push-to-start Lariat. In order to program the linkr-lt2 I had to, with the doors closed, turn the ignition on-off-on and then followed the above instructions. The Evo-One would not enter valet mode by just holding the valet button for 5 seconds. My linkr-lt2 is working great with my Evo-One and THAR-FOR-3 harness.