Questions & Answers

Issue with brown/white providing neg output

0 votes
I have a 30amp 4 pin relay and hooked it up as noted on this forum. I cannot get it to turn on the parking lights while the remote start is running. Any support would be welcomed. 2007 Jeep Wrangler.
posté Mar 8, 2015 dans la catégorie Jeep par JOHN CAFAGNA (130 points)
modifié Mar 8, 2015 par JOHN CAFAGNA

1 Réponse

+1 vote
Can you tell me how you hooked up your relay (pin connections please)
répondu Mar 10, 2015 par J M (64,070 points)
I did the following: Pin 85 to Brown/White wire from Evo Pins 86 & 87 to 10amp fused line to vehicle constant Pin 30 to the parking light wire. I verified this is correct. When i give it power it lights them up. When they are on my multimeter shows 8amps. Not exactly sure how to test the brown/white wire
Is the relay clicking when you lock and unlock or start the vehicle?

 

if you disconnect the BROWN / WHITE wire from the Evo All and pulse pin 85 of your relay with a wire connected to Ground, do your parking lights light up?

 

You can test the Brown / White wire with a multimeter set to DC voltage, put your RED probe to 12v constant and the black probe of your meter to the Brown / White wire of the EVo All,

 

If you start the vehicle, your meter should show 12 volts if the Brown / White wire is outputting a ground properly.
Thanks. The relay works fine. The brown/white wire does not produce a negative output while the Evo is running. :(
...