Questions & Answers

Vehicle starting but messing but

0 votes

I have a 2014 Infiniti Q50, bought the EVO ALL with the thar-nist4 t harness. installed everything and programmed the module and the vehicle started. going inside the car, tried to press the push to start button and no response whatsoever. pressed the key 3x lock to shut the engine off and it turn off all the electricals but engine stayed on with no control at all. unplugged the module from the wires and vehicle turned off instantly and gained all access to vehicle again. Is there something I am doing wrong or is my EVO-ALL module defected? please help...

asked Nov 16, 2021 in Infiniti by yani Younan (130 points)

1 Answer

0 votes
What is the S/N number to the module? This is located on the back of the unit.
answered Nov 16, 2021 by derek g (341,280 points)
SN: 001A07 018627
commented Nov 26, 2021 by yani Younan (130 points)
The flash and options look ok.

 

Was the white 15 pin connector on the t-harness plugged into the BCM?
commented Nov 26, 2021 by derek g (341,280 points)
Everything was plugged in, I did not understand why it was required to cut the white connectors but I didn't do that, would that be causing the issue? And do you have a video of another person installing it so I could see what I was doing wrong?
commented Nov 26, 2021 by yani Younan (130 points)
That is your issue. You cannot use the white 15 pin connector. You must manually connect power and ground as shown in the guide: https://fortin.ca/download/75841/evo-all_ig_tsa_bi_nis4_q50-6c_2014_pts_b_75841.pdf

 

Fortin does not make videos at this time.
commented Nov 26, 2021 by derek g (341,280 points)
Okay, I will try that. Anything else should I check for? Or any options that I should keep on or off?
commented Nov 26, 2021 by yani Younan (130 points)
No the rest looks ok. Simply make the changes that are shown in the installation guide.
commented Nov 26, 2021 by derek g (341,280 points)

Related questions

...